Nothing is better than getting the job done without problems and without losing any time. For you this means: first check the conditions, then get started with the right prime coat for exterior use. Our range of products offers you the right solution for every substrate and every field of application. And we also have practical tips for inspecting the substrate here.

Are you dealing with a substrate that is extremely absorbent or extremely uneven in its absorbency? Then Brillux prime coats for facades are available to even out the absorbency. They are colorless, penetrate deeply and perfectly prepare substrates such as render, concrete, lime sandstone or clinker bricks. Even slightly sandy surfaces are stabilized by our prime coats for exteriors.

Efficient application: our Lacryl Hydro-Gel 695 does not drip and is therefore very easy to apply with a roller. It is also perfect for stabilizing plasters, gypsum plasters and gypsum fillers that are slightly sandy on the surface.

On non-absorbent or low-absorbent substrates, pigmented prime coats with an adhesion-promoting or adhesion-enhancing effect are recommended before subsequent coatings. Choose from different prime coats to suit your system.

Sometimes there are cases that need to be treated very specially. Substrates that require special insulating properties. Or special solutions that ensure good stabilization on sandy and chalky surfaces. These cases call for our special prime coats for special requirements.